Application

Feed from a random loaded, floor mounted hopper. The track pins will be metered from a tub into the hopper via a low level signal cycling a 6000# vibrating hydraulic tub dumper. Then the parts are vertically elevated from the hopper and discharged in a continuous stream onto a horizontal cross-feed conveyor and fed in a continuous stream to an air-operated transfer device. Then the transfer device will load pins into a load chute.


Width

36” Wide Elevating Belt


Drive

2 HP/AC Motor


Parts Fed (Size)

Excavator Track Bushings (2.73”-3.48”Ø x 5.64”-8.87” Lg.)


Feed Rate

2 parts/minute